CloudGate Zhaga 200.

Remoticom CloudGate Zhaga 200 series are the most advanced products in our Zhaga Smart Controller family. It has a GPS, tilt sensor, ambient light sensor, Bluetooth mesh and supports the DALI D4i standard. CloudGate Zhaga 200 is equipped with a SIM chip (MFF2 type) and a nano SIM card holder, allowing the end-user to choose the NB-IoT/LTE-M provider. Using the Lightweight Machine to Machine (LwM2M protocol), the CloudGate Zhaga 200 and other devices can be monitored and configured on the DALI bus. The CloudGate Zhaga 200 can control up to 4 LED drivers (DALI Control Gear) and assign a dimming schedule to each driver. The CloudGate Zhaga 200 can also respond to D4i motion sensors and switch the light when motion is detected.

The CloudGate Zhaga 200 can automatically send a notification to the LwM2M server when a fault is detected, such as when the lamp short circuits, the driver overheats or the streetlight is tilted. The CloudGate Zhaga 200 is controlled by a user-selectable device management system. Remoticoms dimming module allows the user to create dimming schedules and scenes. The user can specify a custom lighting plan with a fine-grained approach, such as specifying weekday schedule, holiday schedule and other events. The operator creates scenes and specifies when these scenes are processed. He can specify weekdays, holidays and/or other recurring/non-recurring events.

The CloudGate Zhaga 200's override mode makes it easy to change the light level of each specific driver in case of emergency. The built-in tilt detection can be used to monitor the luminaire's tilt. The CloudGate Zhaga 200 can automatically notify when a luminaire exceeds the set tilt threshold.

The CloudGate Zhaga 200 supports a sunrise and an ambient light filter mode. When the sunrise filter is enabled, sunrise and sunset times are calculated based on the date and location. During the day, the light is switched off. When the ambient light filter is on, the light is automatically switched off when the sun rises. Otherwise, the lamp operates normally again. The filter mode can be configured separately for each LED driver.

When the CloudGate Zhaga 200 receives a trigger from a D4i motion sensor, such as the Remoticom EnergyNode Motion, the light is set to a certain light level for the duration of the waiting time.